Summary

Legionella risk assessments are sold at two very different price points, and a plumber or heating engineer offering them needs to understand why. At the bottom of the market, letting agents and landlords are offered a "Legionella certificate" for £40–£60 by assessors who spend 20 minutes on site, tick a template and email a PDF; some of these are fine, some are worthless, and the HSE has said repeatedly that there is no such thing as a Legionella certificate and no legal requirement for an annual one. At the top, a competent assessment of a care home or a leisure centre is a day's work by someone with a water-hygiene qualification, producing a schematic of the system, a register of outlets, a temperature survey, a written scheme of control and a monitoring programme — and it is priced in the hundreds or low thousands.

For a tradesperson the opportunity is in the middle: a competent, honest assessment of a domestic let or a small commercial premises that tells the duty holder what their system is, where the risk sits (stored water between 20°C and 45°C, dead legs, little-used outlets, scaled showerheads), and what to do about it, priced to reflect 30–90 minutes on site and an hour of report writing. The follow-on work — removing the dead leg, raising the cylinder stat, fitting a TMV, descaling the showerheads, a six-monthly temperature check — is plumbing, and it is where the assessment earns its keep. This guide gives the price points, the time and the cost base, what a report must contain to be worth the fee, the legal position for landlords (which customers will ask about and which many assessors misstate), and how to structure the follow-on work.

For the technical control measures see legionella risk; for the landlord duties and temperature regime see legionella management; for HMO context see hmo licensing.

Key Facts

Quick Reference Table

Spending too long on quotes? squote turns a 2-minute voice recording into a professional quote.

Try squote free →
Premises Time on site Report time Regional (outside London/SE) South East London
Single let, combi boiler, no storage 30–45 min 30–45 min £60–£100 £70–£120 £80–£140
Single let, cylinder + loft tank 45–60 min 45 min £80–£130 £90–£150 £100–£170
HMO, 4–6 bedrooms, shared bathrooms 60–90 min 1 hr £90–£160 £110–£180 £130–£220
Block of flats, communal cold-water storage and risers (per block) 2–3 hrs 2 hrs £250–£450 £300–£500 £350–£600
Small commercial: shop or office, 1 cylinder, 2–6 outlets 2–3 hrs 2 hrs £200–£350 £240–£400 £280–£450
Dental or GP surgery, hairdresser, small gym with showers 3–4 hrs 2–3 hrs £300–£500 £350–£550 £400–£650
Care home, hotel, school, leisure centre 1 day+ 1 day £400–£1,200+ £500–£1,400+ £600–£1,600+
Review of an existing assessment (no system change) 30–60 min 30 min £50–£100 £60–£110 £70–£130
Monthly sentinel temperature monitoring visit 20–40 min 10 min £40–£80 £45–£90 £55–£100
Cold water storage tank clean and disinfect (to BS 8558) 2–4 hrs — £200–£400 £240–£450 £280–£550

Detailed Guidance

What the customer is actually buying

The report. A Legionella risk assessment with no schematic, no outlet register, no temperatures and no scheme of control is a letter saying someone visited. For the fee to be defensible, the report needs:

  1. Scope and identification — address, duty holder (the landlord or employer), responsible person, date, assessor and their competence (course certificate reference)
  2. System description — mains cold water supply and stopcock; cold-water storage (tank size, location, lid, insulation, condition, temperature); hot water generation (combi, vented cylinder, unvented cylinder, size, thermostat setting, stored temperature); distribution (materials, insulation, secondary circulation, pipe runs); outlets (register with type, location, usage frequency, TMV present)
  3. Schematic — a hand sketch is acceptable for a flat; a line diagram for anything with risers or a cylinder, showing tanks, cylinder, pumps, TMVs, outlets and dead legs
  4. Temperature survey — cold at the sentinel (nearest and furthest) outlets after 2 minutes, hot at the sentinels after 1 minute, stored hot at the cylinder, tank water temperature. Record the ambient and the readings
  5. Risk factors found — water stored between 20°C and 45°C; dead legs and blind ends; outlets used less than weekly (spare bedroom en-suites, outside taps in winter); scaled or dirty showerheads; tank with no lid, debris or sediment; TMVs not serviced; pipework insulated so cold runs warm; susceptible occupants (over 45, smokers, immunocompromised — relevant in care settings)
  6. Risk rating — low, medium, high, with the reasoning
  7. Written scheme of control — the actions, who does them, how often, and where the records go: cylinder stat to 60°C; cut back the dead leg; weekly flush of unused outlets by the tenant (and a note in the tenancy); quarterly showerhead clean; six-monthly tank check; review date
  8. Photographs — tank, cylinder stat, showerheads, any dead leg

A one-page template with tick boxes can carry all of that for a flat. A commercial premises needs a proper document. Either way, the report is the product; the visit is how it is made.

Time and cost base

For a plumber or heating engineer adding assessments to an existing business, the cost base is small: a calibrated thermometer, a one-day course, a report template, and the PI insurance. The time is the price driver:

Element Single let, combi HMO with cylinder and tank Small commercial
Travel (in and out) 30 min 30 min 45 min
Survey and temperatures 30 min 60–90 min 2–3 hrs
Report 30 min 60 min 2 hrs
Total time 1.5 hrs 2.5–3 hrs 5–6 hrs
At £45/hr £68 £113–£135 £225–£270
Add PI and liability margin, 15–25% £80–£85 £130–£170 £260–£340

That reconciles with the Quick Reference Table. It also shows why the £40 "certificate" cannot be done competently: it allows for no report time and no visit beyond the front door. Letting agents who buy at £40 are buying a document, and a plumber who competes at that price is giving away three hours.

For a plumber the better sale is the bundle: assess the HMO at £140, and quote the dead-leg removal, the TMV and the tank lid on the same report at £450–£700. That is a half-day of plumbing at proper rates, sold by the assessment.

The landlord question, answered correctly

Customers will ask whether they legally need this and whether it has to be renewed every year. The honest answer, which is also the HSE's published position, is:

Say this in the quote and the report. A tradesperson who tells a landlord they legally need an annual certificate is misrepresenting the law, and the letting agents who do so have been corrected by the HSE in print. The sale is still there: most landlords want a competent third-party assessment and a written scheme of control because it shows they discharged the duty, and most licensing authorities and agents ask for one. See legionella management and renters rights act 2025 landlord compliance for the wider landlord-compliance context.

Remedials: the follow-on work and how to price it

Remedial What it involves Price (supplied and fitted, regional)
Dead leg removal Trace the redundant run, cut back to the live main, cap, make good £120–£250 per dead leg
Cylinder thermostat to 60°C and anti-scald TMV at bath/basin Adjust stat; fit TMV2/TMV3 valve under the basin or at the bath; test outlet temperature £180–£350 per TMV
Showerhead and hose replacement Replace scaled head and hose; note quarterly clean in scheme £30–£60 each
Cold-water storage tank: lid, insulation, screened overflow and vent to BS 8558 Fit close-fitting lid kit, insulation jacket, insect screens £120–£250
Tank clean and disinfect Drain, clean, chlorinate to 50 mg/l for 1 hour, flush, re-test (to BS 8558 and PD 855468) £200–£400
Secondary return pump or trace heating on long hot runs Where hot outlets will not reach 50°C within a minute £400–£1,200
Outlet flushing regime and record sheet for the tenant Written instruction, sheet in the property file Included in the report
Monthly or quarterly monitoring visit Sentinel temperatures, showerhead check, record £40–£80 per visit

Price materials at trade cost plus 20–30% and the labour at your hourly rate; these are plumbing jobs and the margin is the plumber's margin. See thermostatic mixing valves for TMV selection and domestic hot water cylinder sizing for cylinder temperature settings.

Commercial premises and when to refer on

A shop with a kitchen sink, a staff WC and an electric point-of-use heater is a 2-hour job. A premises with a calorifier, secondary circulation, showers, a cold-water tank room and vulnerable occupants (a care home, a nursing home, a hospital, a hotel, a school with showers) is HSG274 Part 2 territory where the written scheme needs a monitoring programme, a named responsible person, training records and, in some cases, sampling and a water-treatment regime. Price it only if you hold a recognised Legionella risk-assessment qualification and PI cover to match; otherwise refer to a Legionella Control Association member and take a referral or subcontract the remedials. Cooling towers and evaporative condensers (HSG274 Part 1) must be notified to the local authority under the Notification of Cooling Towers and Evaporative Condensers Regulations 1992 and are a specialist's work entirely.

Worked example: 5-bed HMO, vented cylinder, loft tank

Travel                                                    30 min
Survey: tank (loft), cylinder, 2 bathrooms, kitchen,
  5 bedroom basins, outside tap; temperatures at 6
  outlets + cylinder + tank; photographs; sketch         80 min
Report: schematic, register, temperatures, risk rating,
  scheme of control, tenant flushing sheet               60 min
                                                          --------
Total                                                     ~2.8 hrs at £45 = £128
PI/liability margin 20%                                   £26
Assessment fee quoted                                     £150

Findings: tank with no lid, 15°C ambient loft, sediment;
  cylinder stat at 50°C; dead leg to removed bath in bed 3;
  en-suite in bed 5 unused for 6 months.

Remedials quoted on the same report:
  Tank lid kit, insulation, screens                       £180
  Cylinder stat to 60°C + TMV at kitchen and 2 bath/basins
    (3 TMVs)                                              £720
  Dead leg cut back and capped                            £160
  Flushing regime sheet for tenants                       included
                                                          --------
  Remedials                                               £1,060
Total invoice if all accepted                             £1,210

The assessment at £150 is competitive and competent. The job is £1,210 and a day's work. That is the model.

Frequently Asked Questions

How much does a Legionella risk assessment cost for a rental property?

£60–£120 for a single let with a combi boiler, £80–£150 with a cylinder and tank, and £90–£180 for an HMO, in 2026 outside London. The £40 "certificate" offers exist but rarely include a schematic, temperatures or a scheme of control, which are what make the document worth having.

Do landlords legally need a Legionella certificate?

No. Landlords must assess and control the risk, under the Health and Safety at Work etc. Act 1974 and COSHH 2002, but the HSE's guidance is explicit that the assessment can be done by the landlord themselves, that no third-party certificate is required, and that there is no fixed annual renewal. Most landlords still choose a third-party assessment because it evidences the duty, and HMO licensing authorities and letting agents routinely ask for one.

How often should the assessment be reviewed?

When the system or its use changes — a new cylinder, a void period, a new tenant group — and periodically otherwise; two years is the review interval most assessors use, drawn from HSG274 Part 2. Monitoring (monthly sentinel temperatures, quarterly showerhead cleaning, flushing of little-used outlets) is continuous and is set out in the scheme of control, not by repeating the assessment.

Do I need a qualification to do Legionella risk assessments?

There is no statutory qualification, but competence must be demonstrable under L8. The market norm for domestic and small commercial work is a one-day accredited Legionella awareness and risk assessment course, a calibrated thermometer, and professional indemnity insurance that covers written risk-assessment advice. For care homes, hotels and premises with calorifiers and secondary circulation, use a Legionella Control Association member or hold an equivalent qualification yourself.

Should the water be tested for Legionella?

Not routinely in domestic or low-risk premises. HSG274 Part 2 treats sampling as a tool for high-risk systems, systems where temperature control cannot be achieved, or after a case of Legionnaires' disease. Temperature control and flushing are the controls; a lab sample at £40–£80 proves a point on one day and does not replace them.

Regulations & Standards