Summary

Artex is the job that catches plasterers and decorators out on price, because the customer sees a ceiling they want flat and the tradesperson sees four different jobs depending on what the coating is made of and how it is going to be dealt with. The cheapest route, a skim over the top, is only appropriate where the coating is sound, well-bonded and not too deeply stippled. The most expensive route, removing an asbestos-containing coating, is a regulated activity with training, equipment, waste and paperwork that a plasterer who has not priced it before will lose money on. In between are overboarding and wet scraping, each with its own labour rate, materials list and risks.

The pricing discipline is therefore: identify the method first, then price the method. That means an asbestos test before the quote is firm, a stated assumption on the quote about what happens if the result is positive, and a per-metre rate for each method rather than a round number per room. This guide gives the 2026 labour and material build-up for each of the four methods, regional and London bands, a worked example for a typical house, and the compliance costs that have to be in the figure for asbestos-containing coatings. For the technical method (sampling, skim-over technique, wet stripping) see artex removal skim coating and skim over artex and old surfaces; for the asbestos rules in detail see asbestos in textured coatings and control of asbestos regs 2012.

Key Facts

Quick Reference Table

Spending too long on quotes? squote turns a 2-minute voice recording into a professional quote.

Try squote free →
Method Regional (outside London/SE), per m² South East, per m² London, per m² 12 m² ceiling, regional Notes
Asbestos sample (per sample) £30–£80 £35–£85 £40–£90 £30–£80 UKAS laboratory; 1–3 days
Skim over intact coating £15–£30 £18–£35 £22–£42 £250–£450 Sound, well-bonded coating only
Overboard and skim, supplied and fitted £30–£50 £35–£58 £42–£70 £450–£700 12.5 mm board; coving and lights extra
Wet scrape asbestos-free and skim £20–£40 £24–£46 £28–£55 £350–£600 Bonding coat usually needed
Non-licensed/NNLW removal of asbestos coating £40–£70 £48–£80 £55–£90 £500–£900 Trained operatives, RPE, enclosure, waste
Skim after asbestos removal £15–£25 £18–£30 £22–£35 £200–£350 Separate line
Licensed contractor removal £60–£120+ £70–£140 £85–£160 £800–£1,500+ Rare for coatings; contractor's price
Hazardous waste collection £150–£350 per collection £180–£380 £200–£450 £150–£350 Or £30–£60 per bag at a licensed site
Coving off and refit, per linear metre £8–£15 £10–£18 £12–£20 £120–£220 Overboarding only
Decoration, mist coat + two coats £8–£14 £10–£16 £12–£20 £100–£170 Often excluded

Detailed Guidance

Step one: the sample sets the price

A quote for Artex removal before a sample result is a quote for one of two completely different jobs, and the difference is £300–£500 on a bedroom ceiling. The sequence that avoids the argument:

  1. Survey visit — identify every textured surface, note the pattern, the condition (sound, flaking, water-stained, previously painted), the ceiling height, the fittings and the coving. Take a sample from each distinct application using the wet method: dampen the surface, score a 2–3 cm piece into a sealable bag, seal the sample point with PVA or tape, and label it. See artex removal skim coating for the full sampling method and asbestos sampling for the precautions
  2. Laboratory — £30–£80 per sample. Charge the customer for it as a line on the survey invoice or as a line on the quote; it is not free, and the result belongs to them
  3. Quote with the result — either a firm price for the method the result allows, or a quote with two priced options ("if the sample is negative, £X; if positive, £Y") where the customer wants a figure before the result

A coating that has previously been painted with several coats of emulsion is often better sealed than a bare one, but paint does not remove the asbestos, and sanding painted Artex to a key releases fibres just the same.

Pricing a skim-over

The skim-over is appropriate when the coating is sound, firmly bonded, dry and not stippled so deeply that the finish coat cannot cover it. The labour build-up for one plasterer on a 12 m² ceiling:

Item Time / quantity Cost
Sheet up, knock back high points (scraper, no abrasive), clear 0.5 hr —
Bonding agent to the whole surface (two coats on a heavy stipple) 0.5 hr, 1 litre £8–£12
Bonding coat to fill deep pattern where needed 1 hr, half a bag £6–£10
Two-coat skim, trowel up 2.5 hr, 1.5 bags multi-finish £15–£22
Clean up, remove sheets 0.5 hr —
Total 5 hr, materials £30–£45

At a plasterer's day rate of £220–£300 (see plasterer day rate guide) the labour is £140–£200, materials with 20% markup £36–£54, and the charged price £250–£450 for the ceiling, which is the £15–£30/m² band at 12 m². Where the coating is deeply combed or fan-patterned a bonding coat across the whole ceiling adds half a day and a bag, and the figure moves to the top of the band. Note that skim-over does not remove any asbestos; the coating stays in place, sealed, and the customer must be told so that it goes on their records.

Pricing an overboard

Overboarding is the method when the coating is unstable, water-damaged or so deep that a skim cannot hide it, and the customer does not want it removed. Two operatives, 12 m² ceiling:

Item Time / quantity Cost
Locate joists, mark, remove coving, drop light fitting 1 hr —
12.5 mm plasterboard 2400 × 1200, 5 boards with waste 2 hr £45–£65
Screws 38 mm at 230 mm centres, scrim, jointing 0.5 hr £10–£15
Two-coat skim 2.5 hr, 1.5 bags £15–£22
Refit coving (or new), re-hang light with longer fixings 1 hr £20–£60
Total 7 hr for two (14 labour hours), materials £90–£160

Charged at £450–£700 for the ceiling, or £30–£50/m² with the coving and fittings as separate lines. Use 38 mm screws into the joists through the existing board and coating (not into the coating alone), and screw at 230 mm centres on a ceiling; see plasterboard types and plasterboard quantities. Where the ceiling forms part of a fire-separating floor (a flat, or a three-storey house) the board and its fixing must maintain the fire resistance under Approved Document B; a 12.5 mm board over an existing lath-and-plaster or plasterboard ceiling generally improves it, but check before promising anything. Overboarding leaves the asbestos in place; record that on the invoice.

Pricing a wet scrape (asbestos-free)

When the sample is negative and the customer wants the coating gone, wet stripping is a steam or warm-water soak and scrape, which is slow and messy, and it leaves a surface that needs a bonding coat before the skim. Output 8–15 m² a day for one operative plus a half-day for the bonding coat and skim. At £20–£40/m² a 12 m² ceiling is £350–£600 including the skim. It is rarely cheaper than a skim-over, so sell it only where the coating is failing or where the customer wants the original ceiling back (lath and plaster, ornate cornice). Protect the floor completely; the scrapings are wet plaster slurry and they get everywhere.

Pricing removal where asbestos is present

Removal of a textured coating that contains asbestos is generally non-licensed work under CAR 2012, provided it is done by trained operatives using methods that keep fibre release low (wet, by hand, small areas at a time). It becomes notifiable non-licensed work (NNLW) when the coating is removed in a way that breaks it up more, or where the material is badly degraded, and NNLW requires notification to HSE before the work, medical surveillance of the operatives and a record of the work. The decision is the contractor's under HSE's NNLW guidance; if you are not sure, treat it as NNLW or bring in a licensed contractor. See notifiable non licensed work nnlw and hse licensed removal asbestos.

The cost build-up for a 12 m² ceiling, two trained operatives:

Item Cost
Polythene enclosure of the room, floor and walls, airlock at the door £40–£70 materials, 1 hr
Disposable coveralls (Type 5/6), FFP3 RPE, gloves, overshoes — per person per shift £15–£25 each
Wetting agent / steam, hand scrapers, Class H vacuum (hire £40–£80/day if not owned) £30–£80
Removal: wet, scrape into bags at the point of work, 8–12 m² a day for two 1–1.5 days
Asbestos waste bags (red inner, clear outer), labels, tape £20–£40
Waste: 3–5 bags from a 12 m² ceiling, consigned to a licensed site £150–£350
Decontamination, air clearance visual, clean down with Class H 1 hr
NNLW notification (online, no fee) and records, where it applies 0.5 hr admin
Bonding coat and skim (separate line) £200–£350

At two operatives for 1.5 days at £220–£300 each, labour is £660–£900; consumables and waste £300–£600; the removal alone comes to £500–£900 (£40–£70/m²) and the skim is £200–£350 on top. London adds parking, the extra cost of waste disposal and a higher day rate: £55–£90/m². Any quote below £35/m² for removing an asbestos-containing coating is a quote that leaves out the training, the RPE, the waste or all three.

Worked example: three-bedroom semi, all ceilings

Customer wants flat ceilings throughout: lounge 18 m², kitchen/diner 16 m², hall and landing 10 m², three bedrooms 12 + 10 + 8 m², bathroom 5 m². Total 79 m². Samples: six taken, two positive (the two front bedrooms, done in the 1970s), four negative (re-coated in the 1990s with an asbestos-free product).

Samples, 6 × £45                                           =   £270
Positive ceilings, 22 m², non-licensed wet removal
  × £55 (incl. enclosure, RPE, waste)                       = £1,210
Positive ceilings, bonding coat and skim, 22 m² × £20       =   £440
Negative ceilings, 57 m², skim over intact coating × £22    = £1,254
Bathroom (5 m² of the 57) deep stipple: bonding coat
  uplift                                                    =    £60
Coving removal and refit, lounge, 17 lin m × £10            =   £170
Light fittings dropped and re-hung, 7 × £20                 =   £140
                                                             --------
Quote, excluding decoration                                   £3,544
Decoration excluded (mist + 2 coats, 79 m² × £11 = £869 if
  required)
Programme: 6 days — removal 2, skimming 3.5, snagging 0.5

The positive ceilings are 28% of the area and 47% of the price. That is the figure the sample protects.

What goes on the quote

Frequently Asked Questions

How much does it cost to remove Artex from a ceiling?

In 2026, £250–£450 to skim over a sound asbestos-free coating on a 12 m² ceiling, £450–£700 to overboard it, and £500–£900 plus £200–£350 for the skim where the coating contains asbestos and is removed by trained operatives as non-licensed work, all outside London. London is 25–40% more. The asbestos test (£30–£80 per sample) comes first and decides which of those jobs it is.

Can a plasterer remove Artex that contains asbestos?

Yes, if the work is non-licensed or NNLW and the plasterer and their operatives have had asbestos awareness and task-specific training, use wet methods, wear FFP3 RPE and disposable coveralls, enclose the work area, and dispose of the waste as hazardous waste through a licensed carrier. The requirement is in the Control of Asbestos Regulations 2012 (regulations 10, 11 and 16 in particular). Where the coating is badly deteriorated or the method would generate significant dust, it is a licensed contractor's job.

Is it cheaper to skim over Artex than to remove it?

Almost always. Skimming over a sound coating is £15–£30/m²; removal with asbestos present is £40–£70/m² plus the skim. The skim-over leaves the coating sealed in place, which is legal and safe while it stays undisturbed, but the customer should be told it is still there, because the next tradesperson who drills a downlighter hole needs to know.

Do I need to notify HSE to remove Artex?

Not for most textured-coating removal, which is non-licensed work with no notification. Where the method or the condition of the coating pushes the work into NNLW, you notify HSE online before starting (no fee), keep a register of the work and the operatives, and the operatives need medical surveillance every three years. HSE's NNLW decision guidance sets out which is which; if in doubt, notify.

What do I do with the waste?

Textured-coating waste containing asbestos is hazardous waste. Double-bag it in asbestos bags (labelled red inner, clear outer), keep it wet, and either arrange a collection by a licensed hazardous-waste carrier (£150–£350) or take it to a site licensed to accept it (£30–£60 per bag) with a consignment note. Never put it in a general skip or household waste; see asbestos waste disposal.

Regulations & Standards